GFL Gesellschaft Fuer Labortec™ Stainless Steel Single Distillation

Description

• Good distillate quality, conductivity approx. 2.3μs/cm at 25°C
• Heating element made of stainless steel, material no. 1.4876
• Thermostatic low water cut-off, to protect the heating element in case of low water
• Energy-saving through distillation of the heated cooling water
• Degassing of carbon dioxide through vent in the top evaporator with baffle is easily accessible by lifting the lids.
• Storage tank for distillate accepts double the hourly capacity of the unit
• Condenser (cooling coil) in the storage tank, easily exchangeable
• Water supply through a built-in solenoid valve with connection for water pressure hose 1/2 inch (inner
• Ø 12.7mm)
• Cooling water pressure required: >3 bar to max. 7 bar
• After switching on the main switch the solenoid valve opens the water supply and closes it once the storage tank is full, thus avoiding unnecessary waste of water
• cooling water outlet with hose connection 3/4 inch (inner Ø 19mm)
• Water that has not been condensed flows off through the cooling water outlet
• Distillate withdrawal through the drain cock on the front of the unit
• The drain cock can be opened in either continuous or touch position
• An electronic level switch switches the still off when the storage tank is full and restarts it automatically when distillate is withdrawn
• Electronic impurity detector switches the unit off in case of high degree impurities in the evaporator, the red pilot lamp "Clean" will glow
• Drainage of the evaporator through drain cock on the right-hand side of the unit
• Main switch and pilot lamps (yellow pilot lamp for operation and red pilot lamp for cleaning) are on the front of the unit
• Double-walled housing. Housing is made of electrolytically galvanized sheet steel, electrostatically powder-coated with epoxy resin
• Power connection through connection cable; 2 and 4 liter units have German shock-proof type (Schuko) plug