Labconco™ XPert™ Nano Enclosures: 3ft. Width Without Built-in Ionizer

Room air is pulled into the enclosure through the front, flows to the baffle and finally passes through a 99.99% ULPA exhaust filter before returning to the laboratory or cleanroom. Features built-in blower and Guardian™ airflow monitor. With built-in ionizer; separate filtered exhauster is not required.

• Ergonomic air foil with aerodynamic Clean-Sweep™ airflow openings; side spring pin releases air foil for cleaning
• Upper dilution air supply and containment sash foil with side-entry air foils
• Zone-perforated, rear baffle pivots down and removes for cleaning
• Exhaust ULPA filter, 99.99% efficient on 0.12μm particles; accessible from top for leak scanning of entire surface
• True bag-in/bag-out filter disposal system (requires certified technician)
• Built-in blower with dynamically balanced, vibration-isolated motorized impeller and speed control
• 40% Blower reserve allows speed adjustment (by certified technician) as filter loads
• Pressure gauge to monitor filter loading
• Guardian Airflow Monitor continuously monitors airflow; features visual and audible alarms if airflow is outside setpoint range

Construction

• Choice of interior depth (depending on width selected): 50cm (23.4 in.) or 76cm (30 in.)
• Type 304 stainless-steel interior sides, baffle, air foil and integral work surface
• Glacier white and gray, dry powder epoxy-coated aluminum and steel exterior
• Prewired fluorescent lamp and switches for blower and light
• 0.25 in. (0.6cm) Thick tempered safety glass front sash
• 24cm (9.45 in.) Sash opening height on 3 ft. models
• Ergonomically angled and hinged sash pivots upward, locks in up position; wiping seal contains contaminants
• Two utility ports for pass-through of electrical cords

• Sash Opening: 9.4 in.
• At 100fpm Exhaust: 220cfm
• At 100fpm Noise: 58-61dbA
• At 80fpm Exhaust: 175cfm
• At 80fpm Noise: 53-57dbA
• At 60fpm Exhaust: 130cfm
• At 60fpm Noise: 48-53dbA

Ideal for nanoparticle manipulation and dry powder chemical handling